Weatherdock EasyTRX 3 User Manual page 19

Figure: 15 Basic setup screen programming software2
With these few settings your AIS Class B unit easyTRX3 is now ready for receiving and
transmitting AIS data.
As default you can connect your chart plotter via NMEA0183 connection with 38400 baud data
rate at NMEA1 OUT or NMEA2 OUT.
In case that you additional want to connect a VHF radio, please take NMEA3 OUT which is pre-
set on 4800 baud data rate as default.
If you want to integrate the easyTRX3 into your NMEA2000 board net, let's go. AIS and GPS data
are forwarded via N2K OUT.
In the event that these basic settings are 100% fitting your situation, please press "Connections"
for disconnection and shut down the program afterwards.
In chapter 10 you will find information about "Installation".
If you have to change the default-settings to fit your situation, please press "Advanced".
Weatherdock AG
www.easyAIS.com
Seite 19