Advertisement
Installation
Mount the server to a rack in the following procedure.
1. Push the server into rack, and secure it with screws on left and right sides.
Removal
Remove the server from the rack in the following procedure
1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) in "User's Guide" for preparations.
2. Make sure that the server is turned off and then disconnect the power cord or all interface cables from the
server.
3. Remove screws from front left and right sides of server, and take out the server from rack gently and
carefully.
4. Hold the server firmly and remove it from the rack.
Removing Rails
Remove rails from the rack in reverse order of installation steps.
856-129811-101-00
Important
Always install the server with three or more persons.
Important
At least three persons are required to remove the server from rack.
Important
Be careful not to get your fingers caught in the rails or lever.
While more than three persons are supporting the bottom part of the server,
Important
slowly pull out the server.
Do not apply load on the server from top when it is being pulled out. Doing so
cause the server to drop.
6 / 11
Advertisement
