Advertisement
Applying SDR Data
* Be sure to set up SDR after installing 1st CPU.
Cautions
1) When you turn on the power after the replacement of the mother board, the rotation speed of the internal
cooling fan may be fast and slow repeatedly. This incident will not occur after completing SDR set up.
2) When the speed remains fast and slow repeatedly, a large amount of fan failure logs are recorded.
After completing the SDR setup, clear the event logs in Offline Tool(In POST push the [F4] key) before
starting the OS environment of the customer.
3) If the following error message is displayed during SDR setup, that means SDR is being applied to other
than intended models.
This SDR data is not supported. (Not found HWID in mchk_fil)
Operating Procedure
1) Turn power switch of the server node on.
2) Insert the attached [SDR UPDATE TOOL] CD-ROM in the optical disk drive of the servernode.
3) After the CD-ROM is inserted, reset the server by pressing <Ctrl> + <Alt> + <Del> keys, or turn off/on
the power
to reboot the server.
4) The system starts from the CD-ROM and the SDR/PIA setup starts automatically.
2 to 3 minutes is required to complete the setup.
Be sure not to turn off the power during the setup. When the following prompt is displayed, the SDR setup
is completed.
Example)
-------------------------------------
CFG Identify : cfgadrh
SDR Revision : SDR Version 00.01 ← Check * This number is sample
-------------------------------------
All programming complete!!
Remove CD-R, and press <Enter> key.
5) With reference to N codes of the server, be sure to confirm SDR Rev and Product ID are displayed
as follows.
N-code
N8100-1909F/1908F (server node) +
N8101-601F/602F/605F (CPU)
N8100-1909F/1908F (server node) +
N8101-603F/604F (CPU)
*1 "xx.xx" of SDR Version becomes in this product and it becomes Version described in
attached SDR UPDATE TOOL.
856-129811-101-00
← Check
CFG Identify
cfgadrh
cfgadrl
SDR Rev
SDR Revision xx.xx
*1
10 / 11
Advertisement
