Related Manuals for ewheels EW-500
Summary of Contents for ewheels EW-500
- Page 1 Assembly and Setup Instructions EW-500 Electric Wheel LLC - electricwheelstore.com - 888-518-3588 (Toll Free) - One Riverway-Suite1700, Houston,TX 77056...
- Page 2 6. Knife 1. Remove the EW-500 from it’s carton. Start by opening the top to allow access to the inside of the carton. Use a knife to cut each corner from the inside out (Figure A). Once all four corners are cut it will allow 360 degree access to your new moped eliminating heavy lifting.
- Page 3 e wheels wheels Handlebar Installation Tools you will need to attach the Handlebar - 12mm Socket Driver or Socket Wrench w/ Extension - 17mm Wrench 1. Slide Handlebar assembly onto Fork/Steer tube and align corresponding holes. Electric Wheel LLC - electricwheelstore.com - 888-518-3588 (Toll Free) - One Riverway-Suite1700, Houston,TX 77056...
- Page 4 e wheels wheels Handlebar Installation 2. Connect the Handlebar assembly and Fork/Steer tube together with the bolt and radiused spacer provided (Figure B). The notch shown in Figure B needs to be vertically aligned. 3. Once bolt is in, turn the bars to the left or right as far as they will go. This will allow you to finger tighten the locknut on.
- Page 5 e wheels wheels Front Fender Installation Tools you will need to attach the front fender - Phillips Screwdriver 1. Screws come screwed into fender bracket on the forks. You need to unscrew the three screws shown in (Figure C). Align all three holes on the fender with fender bracket on the forks and screw back in. Headlight Installation Tools you will need to attach the headlight - Phillips Screwdriver...
- Page 6 e wheels wheels Headlight Installation 2. Use provide fairing tab to cover wiring harness hole. Snap into place and pull until it matches the radius of the fairing. 3. Attach light using the provide screws. 1 in the front on the light bracket the other 2 on the light itself. Electric Wheel LLC - electricwheelstore.com - 888-518-3588 (Toll Free) - One Riverway-Suite1700, Houston,TX 77056...
- Page 7 e wheels wheels Front Wheel Installation Tools you will need to attach the front wheel - 17mm Wrench - Pliers 1. Unscrew the saddle nut at the end of the brake cable to loosen tension on the front brake. (Figure E). 2.
- Page 8 e wheels wheels Front Wheel Installation 4. Tighten the saddle nut at the end of the brake cable to create tension on the front brake (Figure I). Test front brake as you tighten the saddle nut. Tighten until brake lever has about .75” between the lever and grip. Rear Brake Installation 4.
- Page 9 e wheels wheels Rear Rack Installation Tools you will need to attach the rear rack - Phillips Screwdriver 1. Remove rear pad with phillips screwdriver 2. Attach rack with four screws using a phillips screwdriver 3. Re-install rear pad. Be sure to use the integrated clip when re-installing (Figure M). Storage Box Installation Tools you will need to attach the storage box - Phillips Screwdriver...
- Page 10 e wheels wheels License Plate Holder Installation Tools you will need to attach the license plate holder - Phillips Screwdriver 1. Remove provide screws with phillips screwdriver from license bracket (Figure P). 2. Align plate holder with the holes on licence bracket and re-install all screws and tighten (Figure Q). Pedal Installation Tools you will need to attach the pedals - 15 mm Wrench...
Need help?
Do you have a question about the EW-500 and is the answer not in the manual?
Questions and answers