Related Manuals for Siemens SPCN910
Summary of Contents for Siemens SPCN910
- Page 1 SPCN910 Communication Interface Module (en) STEP: A6V10324565, Edition: 01.02.2011...
- Page 2 Enabling the SPCN910 To operate, the SPCN910 must be enabled. Refer The SPCN910 Communication Interface Module is an interface board that allows the SPC controller to to the configuration sections of this installation operate with third party Alarm Reporting Devices (ARDs). It installs easily and neatly within SPC Grade 2 sheet for details of enabling the module.
- Page 3 Attach the DualCom GPRS unit to the panel with the The SPCY910 Mounting Kit is required when fitting configure and test the SPCN910 from the keypad. adhesive foam pads provided. Ensure that the unit these ARDs in an SPC Grade 2 panel. See the...
- Page 4 Wait approximately five seconds and click the Test button again for the same channel. The light bulb icon SPCN910 switches off. The corresponding LED on the Redcare/DualCom ARD will blink again approximately three times to indicate it is transmitting a ‘channel restore’...
- Page 5 12. Configuring the SPCN910 from the SPC Pro Application Use FULL ENGINEER programming mode to configure and test the SPCN910 from SPC Pro. In the browser, select the appropriate installation for the required SPC controller panel. Connect in to the panel and download the current configuration file.
Need help?
Do you have a question about the SPCN910 and is the answer not in the manual?
Questions and answers