Stop/Start Lamp; Radio Frequency Id (Rfid) Tag - Mahindra THAR m2DiCR Owner's Manual

Table of Contents

Advertisement

the engine, or illuminates while driving, stop immediately, check the
oil level after 2-3 minutes. If low, add engine oil to the "MAX" level
and check status. If problem persists, contact an Authorized
Mahindra Dealer immediately.
Operating the vehicle with the low oil pressure warning lamp
ON could cause sudden unexpected engine failure and loss of
vehicle control, resulting in an accident, personal injury.
Do not run the engine with low oil pressure warning indicator
ON. This may result in engine damage, which will not be covered
by the limited warranty.
Water-in-Fuel Warning Lamp
The water-in-fuel warning lamp illuminates when the
accumulation of water in the fuel filter reaches the
maximum permissible limit. The fuel filter needs to be
drained. Contact an Authorised Mahindra Dealer.
Do not continue driving the vehicle with the water-in-fuel
warning lamp ON. This may result in fuel pump/other fuel
system component damage, which will not be covered by the
limited warranty.
© Copyright Mahindra and Mahindra Ltd. 062016

7.11 Stop/Start Lamp

The Stop/Start - Stop/Start lamp flashes when the
vehicle/engine is about to stop through the Stop/
Start System. The lamp illuminates continuously
when the vehicle/engine has been switched OFF by the Stop/Start
System. On restarting the vehicle/ engine again by using the
clutch/key, the lamp goes out.

7.12 Radio Frequency ID (RFID) Tag

Your vehicle is fitted with a RFID tag as per CMVR regulations on
front windshield.
RFID tag may be used for Electronic Toll Collection (ETC).
Do not peel or remove the RFID.
FEATURES AND CONTROL
7-15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents