Table of Contents
Advertisement
4) FULL VERSION OF FIRMWARE
How to use the FULL firmware1
▷ Camera Status : When turning on the camera, the power consumption (Checking the POWER SUPPLY) is
▷ Cause
: The data of 0 address in the FLASH MEMORY of the MAIN PCB is damaged.
▷ Solution
: Recover the address by doing the FULL VERSION FIRMWARE shown below.
▷ Additions
: After completing the upgrading of the FULL VERSION FIRMWARE, do the LENS
1. Short the 3 point of the MAIN PCB as shown.
2. Assemble the camera correctly and insert the SD card that has the Full version of firmware.
3. Turn on the camera by using the Power Supply.
To connect the camera and Power Supply, use the Battery Tool.
4. If the Current is up to 200mA and down to 0 on the POWER SUPPLY display, the upgrade is complete.
200-300mA and the camera cant be operated.
SHADING and CCD DEFECT CELL adjustment.
41
Ⅲ. ADJUSTMENT
Hide quick links:
Advertisement
Table of Contents
