Toshiba F25Series User Manual page 65

Do not try to remove a memory module with the computer
turned on. You can damage the computer and the device.
Do not remove the memory module while the computer
is in Standby mode. The computer could hang up the
next time you turn it on and data in memory will be lost.
In either of the above cases, the Standby configuration
will not be saved.
The following message appears when you turn on the
power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
2 Pull the clips away from the memory module.
The memory module pops partially out of the slot.
3 Carefully remove the memory module from the slot.
Sample removing the memory module
4 Replace the memory module slot cover and screw.
Getting Started
Adding memory
65