Clock Parameters - Sequential PRO 3 User Manual

Repeats: 1, 2, 3 —
2, each note in the arpeggio plays twice. Set to 3, each note in the arpeg-
gio plays three times.

Clock Parameters

BPM: 30...250—
minute). The
tap tempo
on the low-frequency oscillator, or enabled in the Effects section, the BPM
rate affects the LFO frequency and/or delay effect. When syncing to an exter-
nal MIDI clock source, the BPM setting has no effect.
Selects a basic note value relative to the BPM. See the table below:
Divide—
Name
Half
Quarter
8th
8 Trip
16th
16 Trip
32nd
32 Trip
64th
Pressing the
Tap Tempo—
LED flashes at the BPM rate you set.
Pro 3 User's Guide
Set to 1, each note in the arpeggio plays once. Set to
Sets the tempo for the Arpeggiator in BPM (beats per
LED flashes at the BPM rate. When
Tempo Timing Division
BPM/2 Half note
BPM Quarter note
BPM x 2 Eighth note
BPM x 3 Eighth note triplets
BPM x 4 Sixteenth note
BPM x 6 Sixteenth note triplets
BPM x 8 Thirty-second note
BPM x 12 Thirty-second note triplets
BPM x 16 Sixty-fourth note
tap tempo
button 4 times sets the tempo. The
is enabled
sync
Arpeggiator 59