Barska DX Series User Manual

User's Manual for
Depository Safe DX Series
Read all instructions before using this safe.
WARNING
- For security purposes, change the factory default
code as soon as possible. Factory default
code is: 168#
- Test registered pin code a few times before closing
the door.
- Avoid leaving the safe door open and unattended; it
will allow unauthorized individuals to reprogram the
safe gaining full access to the safe and its contents.
- Store emergency keys in a secure place; NOT inside
of the safe.
- Be careful when opening and closing the
depository slot.
- Keep children away from safe; they should not play
with or around the safe at anytime.
- Note: Barska is not responsible for any installation
damages and any lost or stolen contents.
© 2017 BARSKA ® |
10/17 Pomona, CA 91767, USA
BC555 (t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
PARTS OF THE SAFE
Inside of Safe Door
C
B
A
E
D
Actual model may vary
A. Handle D. Emergency Key Access
(Located behind key pad)
B. Indicator Lights
F. Initialization Button
C. Key Pad
D. Battery Compartment
(Located behind key pad)
BATTERY & KEY ACCESS
Push down on button
located under the key pad
and turn keypad cover
counter clockwise.
DO NOT pull on the wires or
touch the electronic
components.
Install Battery
Insert one new 9V alkaline battery into the battery
compartment and restore keypad cover.
Key Access
Insert access key into key slot and turn clockwise to
open safe.
PIN CODE REGISTRATION
Safe retains 2 pin codes
Safe Default Pin Code: "168"
Changing First Pin Code
1. Open Safe with either Pin Code or Emergency Key.
2. Press initialization button located inside of the safe,
lock will beep wtice and yellow indicator light will be lit.
3. Enter desired Pin Code (1-8 Digits) then press
*
" " button. 2 short beeps will be heard and yellow
F
indicator light will disappear.
4. Use the handle to extend the safe bolts and enter
registered pin code then press " # " button.
If safe can be opened registration was successful, if safe
doesn't open registration was unsuccessful, please
follow steps in Pin Code Registration to register
Pin Code.
Changing Second Pin Code
1. Open Safe with either Pin Code or Emergency Key.
2. Press " 00 " on the keypad, then press the initialization
button located on the inside of the safe, lock will beep
twice and yellow indicator light will be lit.
3. Enter second desired Pin Code (1-8 Digits) then press
*
" " button. 2 short beeps will be heard and yellow
indicator light will disappear.
4. Use the handle to extend the safe bolts and enter
registered pin code then press " # " button.
If safe can be opened registration was successful, if safe
doesn't open registration was unsuccessful, please
follow steps in Pin Code Registration to register
Pin Code.
See reverse side for more information