Barska AX12658 User Manual

User's Manual for Key Safe
Read all instructions before using this safe.
WARNING
- For security purposes, change the factory default
code as soon as possible. Factory default code
is 159 and 011223.
-Test registered pin code a few times before closing
the safe door.
- Avoid leaving door open and unattended; it will allow
unauthorized individuals to reprogram the safe,
gaining full access to the safe and its contents.
- Store emergency keys in a secure place; NOT inside
of the safe.
- To maximize security and performance of the safe,
test pin code every 6 months.
- Test and make sure the safe works properly before
mounting. Once tested, mount the safe before use.
PARTS OF THE SAFE
A
C
B
E
A. Handle
B. Key Access
C. Key Pad
D. Indicator Lights
E. Key Drop Slot
- Located on the side of the safe
© 2023 BARSKA®
855 Towne Center Drive | Pomona, CA 91767
(t) 909.445.8168 | (f) 909.445.8169 | www.barska.com
GETTING STARTED
Remove emergency keys and other included
accessories from packaging.
KEY ACCESS
1. Remove grey key cover located on the safe to expose
key hole.
2. Use emergency key and insert into key hole, turn key
counter clockwise and turn handle clockwise.
BATTERY
Battery compartment is located on the inside of the door
safe.
1. Remove battery compartment cover.
2. Insert four AA alkaline batteries into the battery
compartment and restore battery compartment cover.
Note: Do not mix new and old batteries
PIN CODE REGISTRATION
1st Safe Default Pin Code : 159
2nd Safe Default Pin Code : 011223
1. Press "* *", then yellow indicator light next to warning
will light up.
2. Input current user code that you want to change, and
press "#".
3. Input your new pin code you want to change it to and
press "#".
4. Input your new pin code one more time to confirm
registration and press "#." Yellow light will turn off,
meaning code has been registered.
D
Repeat steps above to change second pin code
TESTING REGISTERED PIN CODE
With safe door open turn handle counter clockwise to
extend the bolts. Enter registered pin code and press "#"
safe should unlock. Turn handle clockwise and bolts
shall retract; if safe unlocked then registration is
complete.
Note: If safe does not unlock then pin code registration
was unsuccessful. Please start over with Pin Code
Registration.
4/23
BC701
DELETING PIN CODES / RESETTING SAFE TO
FACTORY DEFAULT MODE
Please only reset the safe if Pin Codes are lost or
forgotten.
1. Open safe and remove screws securing the back
cover to the safe.
2. You will see a small button located on the
circuit board.
3. Press and hold small button until you see all the
lights flash and 2 quick beeps will be heard.
4. All pin codes have been resetted to factory
Default Pin Codes.
Note: 1st Safe Default Pin Code : 159
2nd Safe Default Pin Code : 011223
LOW BATTERY WARNING
The Red Light comes with Green Light while
entering pin code.
LOCK OUT MODE
If the wrong codes are entered 3 times
consecutively, the keypad will not accept any code,
the beep sound will last for 20 seconds.
If the wrong codes are entered 6 times
consecutively, the keypad will not accept any code
for 5 minutes and the beep sound lasting. You can
remove all batteries to terminate the lockout.
See reverse side for more information