Siemens DI 16x24VDC ST Manual page 14

Parameters/address space
4.1 Parameters
Parameters
Input delay
•
•
•
•
•
•
•
•
•
Potential group
•
•
If you use a floating switch, you need to connect a resistor in parallel so that the wire break diagnostics is enabled in the
1
open state (sensor resistance for the wire break diagnostics: 25 kΩ to 45 kΩ).
Due to the limited number of parameters with a maximum of 244 bytes per ET 200SP station for a PROFIBUS GSD
2
configuration, the configuration options are restricted. If required, you can assign these parameters using data rec-
ord 128 as described in the "GSD file PROFINET IO" column (see table above). The parameter length of the I/O module
is 4 bytes.
14
Range of values
None
0.05 ms
0.1 ms
0.4 ms
0.8 ms
1.6 ms
3.2 ms
12.8 ms
20 ms
Use potential group of
the left module (module
plugged into a dark-
colored BaseUnit)
Enable new potential
group (module plugged
into light-colored Ba-
seUnit)
Default Parameter
reassignment
in RUN
3.2 ms Yes
Use potential No
group of the left
module
Digital input module DI 16x24VDC ST (6ES7131-6BH00-0BA0)
Effective range with configuration
software, e.g. STEP 7 (TIA Portal)
GSD file GSD file
PROFINET IO PROFIBUS DP
Channel Module
Module Module
Manual, 12/2015, A5E03573442-AD
2