Advertisement
Quick Links
Packaging contains:
1) 11 ft of 2" harness webbing,
with stainless-steel grommet
2) 2 tubular sleeves (4" each)
3) 2 tubular sleeves (5" each)
4) 4 Stainless-steel Belt Slides
5) 2 Stainless-steel D-rings
6) 2 Stainless-steel bent D-rings
7) 1 Stainless-steel waist-strap
release buckle
Dive Rite
Basic Harness
Item # BC1063
This harness utilizes nylon webbing
for strength and comfort.
It also features tubular webbing
sleeves to minimize wear wherever
the harness would normally be in
contact with a metal backplate.
This Dive Rite Harness fits on
all Dive Rite backplates.
Great for technical diving,
where simplicity is
the key!
* * Crotch Strap not included * *
© 2015, Lamartek, Inc. dba Dive Rite
175 NW Washington Street
Lake City, FL 32055 USA
www.diverite.com
v1.0
Advertisement
Related Manuals for Dive Rite BC1063
Summary of Contents for Dive Rite BC1063
- Page 1 * * Crotch Strap not included * * 4) 4 Stainless-steel Belt Slides 5) 2 Stainless-steel D-rings 6) 2 Stainless-steel bent D-rings © 2015, Lamartek, Inc. dba Dive Rite 7) 1 Stainless-steel waist-strap 175 NW Washington Street release buckle Lake City, FL 32055 USA www.diverite.com...
- Page 2 Threading Basic Harness BACK STEP Shoulder Strap Routing STEP FRONT Waist Strap Routing 1) Begin by threading 2 tubular sleeves onto the harness webbing. These will end up where the harness goes through the upper shoulder strap slots, as shown in figure A. 2) Thread the harness webbing through the upper shoulder strap slots (figure A), positioning the webbing so the grommet is over the upper tank bolt hole on the plate.
Need help?
Do you have a question about the BC1063 and is the answer not in the manual?
Questions and answers