Cleaning the cooling module
This section explains how to clean the Cooling module.
To clean the cooling module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Remove the battery pack (refer to the
section in Chapter 6, Power and Power-Up Modes, if required).
4. Open the display panel.
5. Slip your finger under a notch at the end of the keyboard brace and lift
up to release latches and remove the keyboard brace.
1. Keyboard barce
6. Remove three screws and the metal fittings securing the keyboard.
1
1. Screws
User's Manual
Turning off the power
1
Figure G-1 Removing the keyboard brace
Figure G-2 Removing the screws and metal fittings
section in Chapter 1, Getting Started if
Replacing the battery pack
2. Metal fittings
TOSHIBA PC Health Monitor
2
G-3