Operational Adjustments; Configure The Thy02 Card - Vertical Express ICON 32 Product Manual

Adjustment Section
Electronic Starter
(continued)

Operational Adjustments

Configure the THY02 Card

Function
ON = Self-test Mode. Unit ignores data link inputs.
ON = Use 50 kHz CAN link.
OFF = Use 100 kHz CAN link.
ON = Use MAMMI Message 8 as play strobe for voice.
ON = Unit display alternately shows lower two ASCII characters of
floors and messages. When displaying a message, "100" LED is lit.
ON = Unit display shows floor position number instead of ASCII
characters.
ON with EEPROM installed = Activate the passing chime when the bit is
set in EEPROM for that floor position number.
ON = Activate floor number redundancy (need same data twice).
Vertical Express Product Manual

7. Press once to access the value.
 
a. Press or to adjust the value of the flashing digit.

b. Press to move to the next digit.

8. Press to exit to the PARAMETERS Menu.
A prompt to ACCEPT or REJECT the change appears. Press

or to reject and correct the parameter.
The THY02 Card, powered by 24VDC, is a receive-only device. See Figure 12.
• REC+ and REC- are for 485 communication protocol.
• CANH and CANL are for CAN communication protocol used with ICON32.
1. Set the S1 Dip Switch #3 to the ON position.
2. Set the controller adjustment O43=9 for the Car CAN Channel (CCL/CCH).
3. Issue a WRT Command.
4. Press RST on the CPUC Card.
Figure 12 - THY02 Card and Dip Switch Functions
2-39
Dip
Switch
1
3
4
5
6
7
8
Operational Adjustments

to accept,
88500 v.1.0