New Age Performance Plus 2.0 Series Manual page 25

3
Attach the Worktop Leg Support to the Worktop using the #8 - 5/8" Philips Head Screws.
A
Installation option A:
Attach one Worktop Support
Leg on each of the front edges
on the Corner Worktop. The
Worktop Support Legs should
be flush along the sides and
back of the worktop
Rotate remaining worktops into position and attach worktop to the support bracket using
4
#8 x 5/8" screws. If there are no additional worktops to install, proceed to Step 5.
A
Follow "Installing Worktop Side Support
5
Tray " instructions on
the other end of the worktop(s).
B
Installation option B:
Attach one Worktop Support
Leg flush to the end of one of
the two worktops.
page 23 to secure
C
Installation option C:
Attach the Worktop Tray, flush
with the end of the worktop.
B
Install worktop wall supports into the
6
wall studs below the worktop using 2.5"
lag screws with 3/16" pilot holes.
25