Boss Modulation MD-200 Owner's Manual page 10

Saving and Switching Memories
Saving to Memory
Here's how to save effect settings that you edited.
1.
Long-press the [MEMORY] button.
The display indicates
2.
Press the [MEMORY] button to select the save-
destination (MAN, 1–4).
If you decide to cancel, press the [TAP DIVISION]
button.
3.
Long-press the [MEMORY] button to confirm
the save-destination.
The memory is saved.
* If you save to MAN, the settings of the panel are applied as the
values for MODE, DEPTH, E.LEVEL, and PARAM 1–3.
10
"Wrt."
Switching Memories
Here's how to recall a saved memory.
1.
Press the [MEMORY] button to select a
memory.
Each time you press the button, you cycle through
the memories in the order of "MAN (manual) 0 1
0 2 0 3 0 4 0 MAN... "
What is "MAN" (manual)?
This unit normally applies the effect according to the
settings that are saved in memory, but if you select MAN
(manual) the effect is applied according to the positions
of the panel knobs. Even in this case, the rate and TAP
DIVISION recall the settings that are written to MAN (this
can be changed).