Configure & Capture; Launch Capture App - Paracosm PX-80 Field Manual

CONFIGURE iPAD +

LAUNCH CAPTURE APP

1. Turn PX-80 on.
2. Turn your iPad on, open Settings > Wi-Fi
and make sure that you are connected to
Configure & Capture
CAPTURE
1. Position PX-80 in case so the bottom of the device is
accessible and attach extension pole.
2. Remove the lens cap from the top camera and turn the
PX-80 on.
3. Make sure the iPad mini 4 is on and
PX-80 hotspot
4. Hold up the device and place in the harness, if using one.
5. Launch Capture app and tap CAPTURE to begin scan.
6. Hold PX-80 upright wait a few seconds and then walk
forward at a steady pace to scan.
7. Tap SAVE or CANCEL to stop capturing.
8. Replace the lens cap, power off the device and return
PX-80 to its case when you're finished.
paired with your