Philips HR4366/22 User Manual page 6

How to remove the filters
- Set the speed selector to position
- Remove the mains plug from the wall socket.
- Remove the side panel by lifting and pulling it
outwards (fig. 5).
- Remove the foam prefilter by gently lifting it
along the bottom edge and pulling it away from
the side panel. (fig. 6).
- To remove the HEPA/carbon filter, hold the filter
by its frame and pull it straight out (fig. 7).
(Type HR 4368: remove the HEPA/carbon filters
on both sides of the appliance).
How to clean the filters
- Wash the foam prefilter thoroughly in cold tap
water to remove dirt and odour (fig. 8).
- Allow the filter to air-dry thoroughly (fig. 9)
before you reassemble it.
(Type HR 4368: clean the foam prefilters on both
sides of the appliance).
NOTE: only the foam prefilter is washable and
reusable, the HEPA/carbon filter is not.
Specifications / technical data
Power consumption
Filter system:
- Pre-filter
- HEPA filter
- Active carbon filter
HEPA/carbon filter
life time
Number of replacement
filters (HR 4990) needed
Suiteable room/area size
How to change the filter
("off"). - Discard the old HEPA/carbon filter with normal
O
- Before replacing the HEPA/carbon filter, clean
- Remove the new filter from its plastic bag and
- Replace the prefilter only when it is completely
- Wipe the screened side panel with a soft, clean
- Put the mains plug back into the wall socket.
- The appliance is ready for use again.
(Type HR 4368: change the HEPA/carbon filter on
both sides of the appliance).
HR 4366 HR 4368
40 Watt 44 Watt
1 2
1 2
1 2
6 months 6 months
1 2
12m 2 /30m 3 22m
6
household waste.
the receptacle area with a clean, soft cloth.
insert it into the air cleaner with the white
pleated HEPA material facing you. Push the
filter in firmly until it rests flush in the filter
receptacle area.
dry.
cloth.
2 /55m 3