Table of Contents
Advertisement
7 lo.m
lo - to select the seek tuning sensitivity
level
m - manual tuning
"lo" is displayed - normal seek tuning
sensitivity
"lo" is off - high seek tuning sensitivity
"m" is displayed - manual tuning with
/ .
Press lo.m several times if required to
select the desired funtion.
8 AUD/LD
AUD – audio
To adjust the treble, bass, balance and
fader.
If the display shows "TREB" or
"BASS", you can adjust the playback
of the treble and bass frequencies
using the rocker switch.
If "BAL" or "FAD" is displayed, you can
set the balance (left/right) and fader
(front/rear).
Press AUD/LD as many times as re-
quired and make the setting using the
rocker switch.
66
The last setting will be stored automa-
tically.
To switch off AUD: Press button once
again.
If you do not change the setting within
8 seconds, the display will switch back
to the previous condition.
LD - Loudness
When the system is played at a low vo-
lume level, the Loudness function
creates a more natural sound by
boosting the low frequency range.
Loudness on/off:
Press AUD/LD for approximately
1 sec.
"LD" lights up in the display, if the
Loudness function is switched on.
9 BND/TS
BND - Toggle switch for the FM me-
mory banks I, II and T. With the Cleve-
land DJ A you can also use BND to
switch over to medium-wave (M) or
long-wave (L).
To switch over:
Press BND as often as required. The
selected mode appears in the display.
TS - Travelstore
To store and recall the five most
powerful stations with Travelstore.
To store: Press button for approxi-
mately 1 sec. until you hear a beep
and "T-STORE" appears in the display.
To recall: Select the memory bank "T"
and press the corresponding preset
button (1 - 5) briefly.
Advertisement
Table of Contents
