Conformity; Fcc - Giant Momentum User Manual

those for which the bicycle was designed.
∙ Damage caused by failing to follow the owner's manual.
∙ Paint finish and decal damage resulting from taking part in competitions, jumping, downhill and/ or
training for such activities or events or as a result of exposing the bike to, or riding the bike in, severe
conditions or climates.
∙ Labour charges for part replacement or changeover.
Except as is provided by this warranty and subject to all additional warranties Giant and its employees
and agents shall not be liable for any loss or damage whatsoever (including incidental and consequential
loss or damage caused by negligence or default) arising from or concerning any Giant bicycle.

7.3 CONFORMITY

Hybrid power bicycles with a maximum support speed of 45km/h fulfil the requirements of
EU Directive 168/2013/EC for L1e-B category vehicles.
Hybrid power bicycles with a maximum support speed of 25km/h fulfil the requirements of
EU Machinery Directive 2006/42/EC.
These bicycles also comply with the following non-harmonized standards:
• Bicycle standard: ISO 4210-2
• Electric bicycles: EN 15194
The declaration of conformity for your specific Giant E-bike can be found as an inlay in this user manual.
Disclaimer
We strongly advise against tampering with your bicycle. Tampering is removing or replacing any
original equipment or modifying your cycle in anyway that may change its design and/or operation.
Such changes could seriously impair your cycle's handling, stability and other aspects of the cycle,
making it unsafe to ride. Tampering can also render your bike not in compliance with the applicable
laws and regulations. To ensure safety, quality and reliability, use only original parts or Giant authorized
replacements for repair and replacement. Giant is not responsible for any direct, incidental or
consequential damages, including, without limitation, damages for personal injury, property damage, or
economic losses due to tampering.

7.4 FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Please note that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
28