Making Hot Water - Gaggia 10002982 User Manual

Making hot water:

Caution! Scalding hazard! Splashing
may occur at the start – scalding ha-
zard! The hot water nozzle and pipe
can reach high temperatures: avoid touching
it directly with your hands.
With the machine ready to brew coffee, proceed
as follows:
1 Press the hot water supply button (4), the
button light will switch on, while the lights of
buttons 2 - 3 - 5 - 6 will switch off.
2 Put a cup and /or a container below the hot
water/steam pipe.
3 Open slowly and clockwise the hot wa-
ter/steam tap knob (25) to allow supply.
Throughout the supply the hot water supply
button light (4) will flash (Fig. 03).
N.B.: A max.supply of 40 seconds is recom-
mended.
4 Take the desired quantity of hot water; to
stop the hot water supply turn knob (25)
counterclockwise.
5 Press button (4) again; the machine will re-
turn to normal running mode. Then remove
the cup and/or the container.
The lights of buttons 2 - 3 - 5 - 6 will switch
on in a fixed mode.
Keeping it clean:
1 IMPORTANT: the steam nozzle should
be cleaned after each use in order to avoid
build up of milk deposits that are very difficult
to clean. Cleaning is made easy as can be
seen in the DESCRIPTION OF PARTS. The
outer part of nozzle can be removed by
pulling downward.
The outside of the steam pipe can be cleaned
with a damp cloth.
The steam jet is cleaned by running a shot
of steam through it.
The hole in the steam nozzle must be kept
open. A needle may be used.
2 Clean filter holder and filter in warm water
after use.
3 Wipe body of machine with a damp cloth
as required.
N.B.: The machine has a sensitive keypad
activated by simply touching or brushing the
sensor areas (keys 2, 3, 4, 6). Turn off the
machine when cleaning in order to avoid
activating it by mistake.
4 Remove basin and grid (12, 23) and rinse
with water. Do not use abrasive substances.
5 Clean the seal (15) inside of the brewing
head (14) and keep it clean.
6 The shower disc (17) should be unscrewed
and cleaned periodically depending on
frequency of use.
7 If the machine is not used for a long period
of time, completely discharge the water
from the boiler by turning the steam knob
(25) clockwise. Press steam switch (5) until
completely discharged. Close the steam
knob (25) by turning it counterclockwise and
switch off the machine.
Never run the pump without water.
8 NOTE: It is very normal for an espresso
machine to emit steam and drip occasionally
as the water pressure changes during use.
• 13 •
ENGLISH
Pay attention as the
Turbo-Frother steam
nozzle could be hot!
Air intake to be kept clean
and free from residues.