Turning On The Tv/Vcr - Philips CCZ252AT99 Owner's Manual

CCZ252comb.QX33 4/6/99 8:50 PM

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure there are batteries in
the remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
SELECT LANGUAGE
1 ENGLISH
2 ESPAÑOL
MAKE SELECTION OR
PRESS EXIT TO CONTINUE
2
Press the Number 1 button to select English on-screen
displays or press the Number 2 button to select Spanish
on-screen displays.
3
Press the STATUS/EXIT button. The screen shown below
will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
4
Press the F.FWD/ B button to begin automatic channel
setup. The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on-screen
briefly. Then the TV/VCR will go to the lowest channel pro-
grammed.
5
Use the CHANNEL o/p buttons or the Number buttons
on the remote control to select a TV/VCR channel. Use
the VOLUME o/p buttons to adjust the sound.
Page 8
ON
1
2
2 3
1
5 6
4 o
8 9
7
p
0
+100
o
p
o
PLAY
REW F.FWD
STOP
p
o
3
p
Helpful Hints
• If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine - 10 to select a language and
set up channels.
• To skip step 2, press the
STATUS/EXIT button. All on-screen
displays will be in English. To skip
step 4, press the STATUS/EXIT but-
ton. Channels will not be set up,
and CHANNELS NOT SET will
appear on-screen briefly.
• You cannot set up channels if you
are using a Cable Box.
• Line Input mode will always be
stored in the TV/VCR's memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on-
screen briefly. Press the CHANNEL
o/p buttons or Number buttons to
select another channel.
5
4