Turning On The Tv/Vcr - Philips CCZ134AT99 Owner's Manual

CCZ134comb 4/5/99 9:30 PM

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure there are batteries in
the remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
SELECT LANGUAGE
> ENGLISH ON
ESPAÑOL
SELECT KL OR
PRESS MENU TO CONTINUE
2
Press the PLAY/K button or the STOP/L button to select
English or Spanish on-screen displays.
3
Press the MENU button. The screen shown below will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
4
Press the F.FWD/B button to begin automatic channel
setup. The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on-screen
briefly. Then the TV/VCR will go to the lowest channel pro-
grammed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on-
screen. Connect an antenna or cable to the TV/VCR, then try
again. You may need to follow the steps on page 10 instead.)
5
Use the CH(annel). Up/Down buttons or the Number
buttons on the remote control to select a TV/VCR chan-
nel. Use the VOL(ume). Up/Down buttons to adjust the
sound.
Page 8
1
POWER EJECT
SLEEP SPEED MEMORY
2 REC/OTR PAUSE/STILL
PLAY
REW F.FWD
STOP
3
STATUS/EXIT
1 2 3
CH.
4 5 6
7 8 9
0
A.CH +100
VOL.
CABLE/DBS COMBI
VCR PLUS+
VAR.SLOW /ENTER
MUTE
TRACKING F.ADV SLOW
SMART SKIP INDEX
PICTURE SEARCH SEARCH
Helpful Hints
• If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine - 10 to select a language and
set up channels.
• To skip step 2, press the
STATUS/EXIT button. All on-screen
displays will be in English. To skip
step 4, press the STATUS/EXIT but-
ton. Channels will not be set up,
and CHANNELS NOT SET will
appear on-screen briefly.
• You cannot set up channels if you
are using a Cable Box.
• Line Input mode will always be
stored in the TV/VCR's memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on-
screen briefly. Press the CH(annel).
Up/Down buttons or Number but-
tons to select another channel.
4
5