Hooking Up The Tv/Vcr - Philips CCZ252AT99 Owner's Manual

CCZ252comb.QX33 4/6/99 8:50 PM

6 Hooking Up the TV/VCR

1
Hook up your TV/VCR using one of the connections shown.
A.
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
B.
Hooking Up Your TV/VCR With a
Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
C.
Hooking Up Your TV/VCR With an
Indoor Antenna
To install a rod antenna (not supplied), push
the stem of the antenna into the antenna hole
on the top of the TV/VCR. Connect the
antenna wire to the ANT(enna) Jack on the
back of the TV/VCR as shown. Extend the
antenna and adjust its length, direction, and
angle for the clearest picture.
Page 6
Connect a Cable signal or an anten-
na to the ANT(enna) Jack.
Connect the Cable signal to the IN
Jack on the Cable Box.
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT
Jack on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
ANT.
ANT.
Rod Antenna
(not supplied)
ANT.
ANT.
ANT.
IN
OUT
ANT.