Hooking Up The Tv/Vcr - Philips CCZ134AT99 Owner's Manual

CCZ134comb 4/5/99 9:30 PM

6 Hooking Up The TV/VCR

1
Hook up your TV/VCR using one of the connections shown.
A.
Hooking Up Your TV/VCR
With a Cable Signal or
Outdoor Antenna
B.
Hooking Up Your TV/VCR
With a Cable Box
To view any channel, set the
TV/VCR to the Cable Box output
channel (channel 03 or 04). Then,
select channels at the Cable Box.
C.
Hooking Up Your TV/VCR
With an Indoor Antenna
To install a rod antenna (not sup-
plied), push the stem of the antenna
into the antenna hole on the top of
the TV/VCR. Connect the antenna
wire to the ANT(enna) Jack on the
back of the TV/VCR as shown.
Extend the antenna and adjust its
length, direction, and angle for the
clearest picture.
Page 6
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal
or an antenna to the
ANT(enna) Jack.
ANT.
Connect the Cable signal to
the IN Jack on the Cable Box.
ANT.
Rod Antenna
(not supplied)
ANT.
ANT.
IN
OUT
ANT.
ANT.