Rear Panel - Philips VRA999PH Owner's Manual

26 Rear Panel

CABLE BOX Jack
Connect the Controller here. You may
use the Controller with either a Cable
Box or a DBS receiver. Details are on
pages 45-49.
S-VIDEO OUT Jack
Connect an S-Video cable going
to the S-VIDEO IN jack of a TV
here. You may use S-Video
connections instead of the
standard RCA-style video (yellow)
connections. S-Video connections
provide a better picture.
S-VIDEO IN Jack
Connect an S-Video cable coming
from the S-VIDEO OUT jack of a
camcorder or another VCR here.
AC Power Cord
Connect to a wall outlet
(120V) to supply power to the
VCR.
VIDEO IN Jack
Connect a video cable coming from
the VIDEO OUT jack of a camcorder
or another VCR here. Details are on
page 50.
VIDEO OUT Jack
Connect a video cable going to the
VIDEO IN jack of a camcorder or
another VCR here. Details are on
pages 50 and 53.
LP 30561-003
IN OUT
CABLE
BOX
R
S-VIDEO
AUDIO
IN OUT
L
(MONO)
VIDEO
AUDIO IN Jacks
Connect audio cables coming from
the AUDIO OUT jacks of a
camcorder, another VCR, or an audio
source here. Details are on page 50.
AUDIO OUT Jacks
Connect audio cables going to the
AUDIO IN jacks of a camcorder,
another VCR, or an audio system
here. Details are on pages 50 and 53.
LITHIUM BATTERY
Compartment
Place the lithium battery here to
save programmed timer recordings,
even in the event of a power failure.
Details are on page 10.
ANT. IN
RF OUT
CH3
CH4
RF OUT Jack
Use the supplied RF coaxial
cable to connect this jack
to the ANTENNA IN Jack
on your TV or to the IN
Jack on your Cable
Box/DBS (if applicable).
Details are on pages 6-9.
ANT(enna) IN Jack
Connect your antenna or
cable here. Details are on
pages 6-9.
CH3/CH4 Switch
Set to channel 3 or 4 to use
your TV with your VCR. Set
your TV to the same channel.
Details are on pages 6-9.