Cisco NCS 5500 Series Hardware Installation Manual page 137

LEDs
Table 10: System Controller LED Descriptions
LED
ATTN
STS
ACT
Color Status
Flashing blue The operator has activated this LED to identify this module in the chassis.
Off This module is not being identified.
Green This module is operational.
Amber The host kernel has booted and is ready to start System Administrator VM.
Red Either of the following conditions:
• The module has detected a slot ID parity error and will not power on or
boot up.
• The module is not fully inserted.
Off The module is not receiving power.
Flashing The module is booting up or shutting down.
Amber
Flashing Red The module has active major or critical alarms.
The controller module is operational and in active mode. This mode is
Green
established after the SysAdmin VM is booted up.
Amber The controller module is operational and in standby mode.
Off The hardware mastership has not been established.
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
LEDs
131