Switching On; Preparation - Miele PLW 6111 Operating Instructions Manual

OPERATION
6.3

Switching on

The machine is switched on and off using a power switch.
Take note of any fault or warning messages on the display when starting the machine.
6.4

Preparation


Follow the manufacturer's instructions for reprocessing.

Make sure that the items are suitable for reprocessing in a laboratory glassware washer
and check the compatibility with the chemicals used during the wash programs.

Place the wash items carefully into the load carriers.

Make sure that wash items are not shielded or concealed by other items.

Position wash items in such a way that fluids can drain off freely.

Tall or heavy items should be placed toward the middle of the basket if possible to
facilitate washing.

Make sure that items do not block the spray arms and that the arms can turn freely.

Distribute the wash items evenly across the baskets.

The mobile units, baskets, modules, and inserts that hold the wash items must be used
only as intended.

Empty any containers or utensils before loading them.

Take apart any items which can be dismantled according to the manufacturer's
instructions and process the individual parts separately from each other.

Do not place items to be cleaned inside other pieces where they may be concealed. Do not
place items so close together that cleaning is hampered.

Arrange the wash items so that wash water can access all surfaces.

Only reprocess small items and micro components in special inserts, mesh trays with lids,
or mesh inserts.

Plastic items must be thermally stable.
REV.0.01_COD.650184_A4
WARNING
Connectors that are not in use must be closed using the caps provided.
Additional caps are available from Miele.
Page 26