Kuryakyn 3225 Quick Manual

LED RUN/BRAKE REAR FENDER TIP

PARTS INCLUDED

1 Lighted Rear Fender Trim Assembly
1 Hardware Kit Containing
1 6 Plug Wire Harness Adapter
4 4" Nylon Cable Ties
1 Dielectric Grease Packet
2 Nylon Cord Keepers
1 Alcohol Pad
1 Installation Instructions
Please read and understand entire instructions before starting installation.
THANK YOU FOR CHOOSING K
IN ORDER TO PROTECT YOU AND OTHERS FROM POSSIBLE INJURY AND/OR
PROPERTY DAMAGE OR LOSS, PLEASE PAY CLOSE ATTENTION TO ALL
INSTRUCTIONS, WARNINGS, CAUTIONS AND ATTENTION NOTES REGARDING
THE USE AND CARE OF THIS PRODUCT.
WARNING!
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING
THE CONTENTS DESCRIBED HEREIN CAN RESULT IN
POTENTIAL DEATH OR SERIOUS INJURY
ATTENTION!
This indication alerts you to the fact that ignoring the contents
described herein may negatively affect product performance and
functionality.
CAUTION! This indication alerts you to the fact that ignoring the contents
described herein can result in potential injury or material
damage.

TOOLS SUGGESTED

Set of Metric Hex wrenches, Set of Metric Combination Wrenches, Masking tape or
Non-Permanent Marker, Cleaning Supplies, Clean Towel
STRICTLY OBSERVE THE FOLLOWING GUIDELINES IN ORDER TO USE THE
PRODUCT PROPERLY AND AVOID POTENTIALLY DANGEROUS ACCIDENTS.

STEP 1

Read and understand all steps in the instructions before starting the
installation. Park the motorcycle on a hard, level surface and turn off the
ignition.
CAUTION! Avoid potential electrical shock! Disconnect the battery before
starting this procedure.

STEP 2

Remove the four fasteners that secure the rear license plate panel. Some
earlier models may have a fifth fastener behind the license plate. Gently pull off
the back panel exposing the wiring harness. (Red and Blue plugs)
PIC 1 and PIC 2
-cont.-
3225-31GL-0111
ϋ
RYAKYN!
3225