Cadet Portable Baseboard Owner's Manual page 4

OPERATING INSTRUCTIONS
1. Do not tamper with the high-
temperature safety shutoff.
After placing your heater on the floor, plug it in, turn it to the highest setting and allow it to run for at
least 30 minutes. If your room doesn't get warmer, please contact us.
PLEASE NOTE: On initial start-up, some smoking may occur as the element initially burns off residue
from manufacturing. It typically goes away within several hours. If it persists, turn your heater off,
unplug it and contact customer service toll free:
855.223.3887 (from US) or 800.668.6663 (from Canada)
live chat: cadetheat.com/customer-service
How to operate your heater
The room temperature is controlled by the thermostat on the heater. Simply plug it in and follow the
steps below to adjust the temperature to your comfort level.
1. Turn the thermostat knob all the way to the right.
2. When the room reaches your comfort level, turn the knob to the left, just until it clicks. The heater
will automatically keep the room temperature around this setting.
3. To reduce the room temperature, turn the knob to the left. To increase the room temperature, turn
the knob to the right.
The larger dots indicate a higher temperature setting. The smallest dot is an OFF position.
High-temperature and safety tip-over shutoffs
Your portable electric baseboard comes with a built-in high-temperature safety shutoff that stops
electricity flowing to the heater if it gets too hot inside. This automatically resets after cooling.
Your heater also includes a safety tip-over switch that disconnects power if it falls over, and resets as
soon as the heater is standing up again.
4
2. Do not operate without the feet
attached.
OFF