Installation - FWE R-AS-10 Installation Manual & Operating Instructions

FWE MOBILE REFRIGERATED AIR SCREEN
INSTALLATION & PROPER LOCATION

INSTALLATION

LOCATION:
Selecting a proper location for your Air Screen Refrigerator is very important.
ALWAYS:
✔ Install to assure that unit is level.
✔ Install to assure that unit is away from extreme heat.
✔ Install to assure that unit is away from a steamer.
✔ Install to assure that unit is NOT placed near or under
a ventilation duct or hood, (this will disturb the
airflow of the Air Screen and will hamper the performance of the unit).
✔ Install to assure that unit is 6'' minimum distance from back of unit
to wall or obstruction (ie; a wall).
✔ Install to assure that the door(s) may open a minimum of 90 degrees.
CLEARANCE:
It is important for the proper operation and longevity of your FWE Air Screen that it have adequate
provisions for air supply to the compressor. Allow approximately 6'' - 12'' between the back grill of the unit
and the wall for proper air flow.
INSTALLATION STEPS:
A. The outside carton has already been removed and inspected for damage. Remove all packing and
strapping material from the exterior and interior of the unit. (Note: Packing material should be saved
should there be any damage to unit.)
B. Remove the FWE Air Screen from the shipping skid. This is done by tilting the unit and rolling it
off the skid. Do not lay the cabinet down.
D. Tray slides have tabs formed into the side of the support. Simply put the tab into the square hole in the
side of the cabinet and push down to seat. The supports can be installed in a horizontal plane or can be
mounted in a slightly sloped orientation to cause the product to slide forward on the sheet pans.
E. The LED digital temperature display is powered up when the unit is plugged in, it registers temperature
in Fahrenheit degrees. The unit can be set up to show temperatures in Celsius degrees. (See Page 9,
ON/OFF Switch for Instructions.)
NEVER:
✖ Never install equipment in
✖ Never install near or under a
✖ Never install equipment in an
-6-
an area of standing water
ventilation hood or duct return
area not conductive to safe and
proper operator use.