Table of Contents
Advertisement
IMPORTANT!
– Use CLOCK•TIMER on the set to set the
clock and timer.
– CLK•TIMER on the remote control allows
you to view the times only.
View clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(CD or TUNER for example)
G Press CLOCK•TIMER (or CLK•TIMER on the
remote control).
➜ The clock is displayed for a few seconds.
➜ If the clock has not been set, "--:--" is
displayed.
Clock setting
The clock can be set in either 12-hour or
24-hour mode ("AM 12:00" or "00:00" for
example)
1
In standby or view clock mode, press
CLOCK•TIMER once. In other source mode,
press CLOCK•TIMER twice.
2
Press PROGRAM repeatedly to select clock
mode.
➜ "AM 12:00" or "00:00" starts flashing.
3
Press à or á on the system repeatedly to set
the hour.
4
Press í or ë on the system repeatedly to set
the minute.
5
Press CLOCK•TIMER again to store the
setting.
➜ The clock starts working.
To exit without storing the setting
G Press Çon the system.
Notes:
– The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
– During clock setting, if no button is pressed
within 90 seconds, the system will exit clock setting
mode automatically.
Timer setting
The system can switch on to CD, TUNER, or
TAPE 2 mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
Clock/Timer
23
Advertisement
Table of Contents
