Table of Contents
Advertisement
Basic Functions
Switching on/to standby and
selecting functions
1
Press POWER to switch on (or .POWER ON
on the remote control).
➜
The POWER indicator lights up
➜
The system switches to the last source
selected.
2
To select your function, push FUNCTION to
TUNER, TAPE or CD.
3
Press POWER to switch the system to standby.
Volume control
1
Check the system is switched on.
2
Adjust the volume with VOLUME control.
Helpful hints:
– In the standby mode, the volume level will be
retained in the system's memory.
IMPORTANT!
– Adjust the volume to a moderate level
before you switch the system to standby
mode or plug in the headphones.
12
Sound control
●
On the set, Press DBB (Dynamic Bass
Boost) once or more to turn bass
enhancement on or off .
Helpful hints:
– Some discs or tapes might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce
the volume.
Reset
If desired, you can restore your system to its
default setting.
1
Remove the power plug from the wall socket.
2
Use a ballpoint pen to press the RESET for
more than 30 seconds.
3
Reconnect the power plug .
➜ The system is restored to its default setting.
Advertisement
Table of Contents
