Table of Contents
Advertisement
Tuning to radio stations
1
Press POWER to on, then push FUNCTION
to TUNER.
2
Adjust BAND to select your desired
waveband, MW or FM ST.
3
Turn TUNING to tune to a station.
- FM ST. lights up for stereo FM reception.
To improve radio reception:
●
For FM, extend and turn the wire antenna for
best reception.
To tune to a weak FM station, adjust BAND to
FM (mono).
●
For MW, the set uses a built-in antenna. Direct
this antenna for best reception by turning the
whole set.
Tape Operation
IMPORTANT!
– Before playing a tape, check and
tighten slack tape with a pencil. Slack
tape may jam or burst in the
mechanism.
– C-120 tape is extremely thin and is
easily deformed or damaged. It is not
recommended for use in this system.
– Store the tapes at room temperature
and do not put them too close to a
magnetic field (for example, a
transformer, TV or speaker).
Loading a tape
1
Press POWER to on, then push FUNCTION
to TAPE.
2
Press 70 to open the tape deck door.
3
Load the tape with the open side downward
and full spool to the left.
4
Close the tape deck door.
Radio Reception
Playing tapes
●
Press £.
●
To pause playback, pressÅ. To resume playback,
press Å again.
●
By pressing à / á , fast winding of the tape is
possible in both directions. To stop fast winding,
press 70.
●
To stop the tape, press 70.
Helpful hints:
– During playback, the keys are automatically
released at the end of a tape (unless Å has been
activated).
– During fast forwarding/rewinding, the keys will
not be released at the end of a tape. To stop fast
winding, press 70 .
15
Advertisement
Table of Contents
