Advertisement
Before Installing
1. Check the pressure of cold and hot water supply
Make sure the cold water supply pressure is higher or equal to the hot water
supply pressure.
When the water supply pressure is higher than 125PSI (862kPa), be sure to
reduce the pressure within a range of 20 to 80 PSI by using a pressure
reducing valve available in the market.
Optimum working pressure range is from 7PSI to 125PSI (60kPa to 862kPa).
Make sure the water pressure is within this range.
2. Check the temperature of hot-water supply
Never use steam as a hot-water supply.
Make sure the temperature range of hot-water supply is within 140 to
o
o
185
F(60 to 85
C).
This is not mandatory for the lower limit but is recommended.
The Automatic Faucet does not discharge hot water exceeding 122
3. Piping
Flush all water lines prior to installation.
4. Others
Pay special attention so that the sensor surface is not awed or scratched.
Prepare stop valve and exible hose or copper tube.
Do not place other devices using inverter or infrared sensor near the
Automatic Faucet, this may cause malfunction.
There is no problem with the Automatic Faucet if the water remains inside.
Some models may have di erent components as illustrated below.
Battery type
10-1/4"
(260
mm
8"(203
o
F(50
o
C).
F.L.
EcoPower
10-1/4"
(260
mm
8"(203
F.L.
Set-up Drawing
)
34"
(864
HOT
1-1/2"
(38
)
mm
COLD
)
mm
6"
3-3/4"
(152
)
(95
)
mm
mm
1"
1"
(25
)
(25
)
mm
mm
type
)
(864
HOT
1-1/2"
(38
)
mm
COLD
)
mm
6"
3-3/4"
(152
)
(95
)
mm
mm
1"
1"
(25
)
(25
)
mm
mm
)
mm
16-7/8"
(428
)
mm
1-2/3"
17-1/8"
(42
mm
(436
)
mm
6-1/2"
(165
mm
34"
)
mm
16-7/8"
(428
)
mm
1-2/3"
17-1/8"
(42
(436
)
mm
mm
6-1/2"
(165
mm
)
)
)
)
Advertisement
