Automatic Shut-Off - Philips GC9930 Quick Start Manual

3
Refreshing
Refreshing button
B
Air vent
C
Air vent slide
D
Board tilting button
H
Height adjustment lever
I
Locking strap
J
Mains plug
M
Refreshing tips and tricks
E
• Perfect to remove food or cigarette smoke smells from
jackets, coats and sweaters.
• Combine the refreshing mode with the steaming mode to
refresh garments and remove creases at the same time.
1
4

Automatic shut-off

1
5
Storage
1
2
Put the mains plug in an earthed
M
wall socket. The power-on light goes on.
Undo the locking strap and unfold
J
the ironing board to vertical position.
Set both air vent slides to the
D
refreshing position.
This appliance is equipped with an automatic shut-off function. When the iron or steamer is not used for
more than 10 minutes, the appliance automatically shuts off and is in standby mode. You hear a few beeps and
the green power-on light stays on.
1 To deactivate the automatic shut-off function, press the power-on button on the iron or steamer once.
The power-on light flashes.
2 Wait for the light to stop flashing. When the light stays on, the appliance is ready for use again.
Fold the ironing board to the storage
position and lock the board with the
locking strap.
To store the cord, briefly pull it towards
you and then let it go. The cord is
wound up automatically.
B
C
D
H
I
J
M
2
Press the refreshing button
back of the ironing board.
The appliance starts refreshing your
garment.
This process takes 10 minutes and
stops automatically.
3
You can now easily move the appliance
by pulling it along by the board handle.
on the
B