Philips GC9940 Service Manual

Philips GC9940 Service Manual

Wardrobe care
Hide thumbs Also See for GC9940:

Advertisement

Philips Consumer Lifestyle
Service Manual
PRODUCT INFORMATION
Safety Information
- This product meets the requirements regarding
interference suppression on radio & TV.
- After the product has been repaired, it should function
properly and has to meet the safety requirements & legal
regulations as laid down & officially established at this
moment.

Features

Iron
- Power on button
- Suction & blowing button for active board
- Steam trigger
- Auto shut off in 10 minutes
- Iron ready in 2 minutes
- Iron hose cord 1.6 m
- Steam rate 120 g/min
Published by Philips Consumer Lifestyle
11/07
Ironing Board
- Board cover
- Active & passive boards (Longer portion is the Active
board)
- Unique board with one end especially for shirts
- Bi-directional fan on Active board for blowing & suction
- Board tilting mechanism
- Board folding & locking strap for storage & transport
- Height adjustment for board 0.75 m to 1.00 m in
21 intermediate steps
- Rod hanger for steamer mode
Stand
- Automatic calc-cleaning system (3 minutes to complete)
- Detachable water tank with anti-calc cartridge
(1.6 L capacity)
- Boiler up to 6.0 bar pressure
- Heat resistant storage compartment for iron
- Automatic cord-winder 2.5 m effective length
- Wheels for ease of mobility
- Detachable rinse tank 0.75 L
- Standby lamp
- Auto Calc Clean lamp
- Replace Cartridge lamp : Red
- Water tank lamp
- Rinse tank lamp
Printed in the Netherlands
Wardrobe Care
: Green
: Blue
: Red
: Red
© Copyright reserved
GC9940
Subject to modification

Advertisement

Table of Contents
loading

Summary of Contents for Philips GC9940

  • Page 1 - Auto Calc Clean lamp : Blue - Replace Cartridge lamp : Red - Water tank lamp : Red - Rinse tank lamp : Red Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright reserved Subject to modification 11/07...
  • Page 2 TECHNICAL INFORMATION GC9940 - Power Maximum : 2300 W at 230 V, 10 A Auto Calc Cleaning System Boiler : 1370 W When the Auto Calc Clean process is activated, the blue Iron : 800 W Auto Calc Clean light blinks and there will be beeping : 40 W sounds.
  • Page 3 DISASSEMBLY ADVICE - IRON ASSEY GC9940 PARTS LIST - IRON ASSY BACKPLATE ASSY 13 Service code Description HOSE CORD IRON 12 4239 020 03021 Iron assy Disassemble BACKPLATE SCREW CAP 20 4239 021 61371 Soleplate mounted assy Remove Screw A1, A2...
  • Page 4 EXPLODED VIEW - IRON ASSEY GC9940 4-16...
  • Page 5 DISASSEMBLY ADVICE - STAND ASSY GC9940 WHEEL ASSY 44 RINSE TANK ASSY 56 CAP ASSY 46 FOOT ASSY 43 E-RING 45 PANEL FRONT BOTTOM 52 Disassemble CAP WHEEL 46 CHASSIS BOILER ASSY 23 Disassemble E-RING 45 Disassemble WHEEL ASSY 44...
  • Page 6 PARTS LIST - STAND ASSY GC9940 Service code Description 4239 020 03011 Chassis boiler assy 4239 016 81880 Strap 4239 017 12361 Wire assy LED - Rinse tank 4239 017 12371 Wire assy - Rinse tank switch 4239 017 09890...
  • Page 7 EXPLODED VIEW - STAND ASSY GC9940 7-16...
  • Page 8 EXPLODED VIEW - CHASSIS BOILER ASSY 23 GC9940 8-16...
  • Page 9 BLOCK DIAGRAM GC9940 RINSE E-VALVE IRON IRON CORD L,N,E,COMM 4x Conductor IRON E-VALVE 24 V DC, GND, DIR Sig, PWM Sig PUMP BOILER 4x Conductor STAND ELECTRONICS 3x Conductor CONTROLLER MAINS PLUG Isolated 5V DV, GND 24 V DC, 5 V DC, 2x GND...
  • Page 10 ELECTRICAL DIAGRAM GC9940 BOILER, SIDE VIEW 620 mm / AWG26 (XLPE) 4239 017 1238 620 mm / AWG26 (XLPE) STDBY 4PT-M (mains) THERMAL 4PT-F FUSE 4239 017 1239 620 mm / AWG26 (XLPE) 4239 017 1214 Calc Reed Sw Wire Assy...
  • Page 11 - This process lasts approximately 3 minutes. 6. The CARTRIDGE BLUE PACK ASSY 61 (GC018) is ONLY for use in GC9940 / GC9950. It should NOT be used in GC9920. 7. For GC9920, please use CARTRIDGE BROWN PACK ASSY (GC017) ONLY.
  • Page 12 DISASSEMBLY ADVICE - IRONING BOARD GC9940 PARTS LIST - IRONING BOARD WIRE ASSY SIGNAL 71 Service code Description FAN GASKET 68 4239 017 12171 Wire assy Board chassis CW FAN ASSY 69 4239 021 49753 Board housing Active 4239 026 33183...
  • Page 13 EXPLODED VIEW - IRONING BOARD GC9940 Fan grile R1 - R4 13-16...
  • Page 14 DISASSEMBLY ADVICE - MOVING COLUMN GC9940 Remove screw F5 MOVING COLUMN ASSY 15 Press Handle lift left & Handle lift right Remove screws F1 - F4 Pull upwards IRONING BOARD-MOVING COLUMN Disassemble BACK COVER TOP 53 assy, detaching completely from the Stand.
  • Page 15 DISASSEMBLY ADVICE - MOVING COLUMN GC9940 Remove screws U1 - U4 Disassemble MOVING COLUMN ASSY 62 Disassemble Plate pivot fl ange left Disassemble Plate pivot fl ange right Disassemble Handle lift left Disassemble Handle lift right Remove screws V1 - V8...
  • Page 16 EXPLODED VIEW & PARTS LIST - MOVING COLUMN GC9940 Plate pivot flange left Handle lift left Plate pivot flange right Handle lift right Service code Description 4239 020 03051 Moving column assy 16-16...

Table of Contents