Tuning to radio stations
1
Press TUNER.
➜
"FM" or "AM" is displayed. A few seconds later,
the current radio frequency will appear on the
display.
2
Press TUNER again to select the desired
waveband : FM or AM.
3
Hold S / T (or ALBUM +/- (à / á)
on the remote control) and then release the
button.
➜
The system will start searching for a radio
station with sufficient signal strength.
4
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press S / T (or
ALBUM +/- (à / á) on the remote control)
briefly and repeatedly until you have found
optimal reception.
Radio Reception
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
1
Press TUNER to select TUNER mode.
2
Press and hold PROG/CLOCK (or
PROGRAM on the remote control) until
"AUTO" is displayed.
➜
starts flashing.
PROG
➜
AUTO is displayed and available stations are
programmed in order of waveband reception
strength.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the first preset radio station will be played.
To stop storing the automatic preset
●
Press Ç.
19