Signode DF-2D Operation, Parts And Safety Manual page 7

LOADING AND THREADING, Continued
NOTE: The strap can also be threading
over the idler wheels by inserting the
strap from the side by pushing the
spring loaded keeper roller back
allowing the strap to pass under as
shown.
9. Continue to thread the strap under the
first lower idler wheel.
10. Continue threading the strap up to the
next idler wheel. Continue threading the
strap through all idler wheels. Refer to
the threading diagram on page 8 if
necessary.
11. Once all idler wheels have been threaded
properly, hold the strap end taunt to
keep the strap from unthreading from the
idler wheels.
12. Release the lower arm from the loading
latch. Return the loading latch back up
to its resting position. The lower arm will
begin to slowly drop. As the arm drops,
strap will begin to payoff from the coil.
NOTES: Once the arm has dropped the
brake will engage stopping the coil of
strap from spinning. Not placing the
loading latch back to its resting position
could interfere with the operation of the
dispenser.
7