Table of Contents
Advertisement
AUTODOME IP starlight 5000i
1.4
Important safety instructions
Read, follow, and retain for future reference all of the following safety instructions. Follow all
warnings before operating the device.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Protect all connection cables from possible damage, particularly at connection points.
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems accepts no liability for any damages or
losses caused by incorrect or improper installation.
All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at
least 3 mm, into the electrical installation of the building. If it is needed to open the housing,
use this all-pole switch as the main disconnect device for switching off the voltage to the unit.
Camera signal - Protect the cable with a primary protector if the camera signal is beyond 140
feet, in accordance with NEC800 (CEC Section 60).
Fuse rating - For security protection of the device, the branch circuit protection must be
secured with a maximum fuse rating of 16A. This must be in accordance with NEC800 (CEC
Section 60).
Outdoor signals - The installation for outdoor signals, especially regarding clearance from
power and lightning conductors and transient protection, must be in accordance with NEC725
and NEC800 (CEC Rule 16-224 and CEC Section 60).
Power disconnect - Units have power supplied whenever the power cord is inserted into the
power source, or when High Power-over-Ethernet (High PoE) power is provided over the
Ethernet CAT 5E/6 cable. The power cord is the main power disconnect device for switching
off the voltage for all units. When High PoE or PoE+ (820.3at) is used to power the unit, the
power is provided over the Ethernet cable, which is then the main power disconnect device
for switching off the voltage for all units.
Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security
Systems cannot be held liable for any damage that results from missing video information.
To minimize the risk of losing information, we recommend multiple, redundant recording
systems, and a procedure to back up all analog and digital information.
Caution!
Always securely tighten all fittings to ensure a liquid-tight seal. Failure to do so could allow
!
water to enter the housing and damage the units. If a sealant is used, ensure that it is a
neutral cure type. Sealants that release acetic acid may harm electronics. Use drip loops on
the wiring outside the housing.
Bosch Security Systems
Clean only with a dry cloth. Do not use liquid cleaners or aerosol cleaners.
Do not install device near any heat sources such as radiators, heaters, stoves, or other
equipment (including amplifiers) that produce heat.
Never spill liquid of any kind on the device.
Take precautions to protect the device from power and lightning surges.
Adjust only those controls specified in the operating instructions.
Operate the device only from the type of power source indicated on the label.
Unless qualified, do not attempt to service a damaged device yourself. Refer all servicing
to qualified service personnel.
Install in accordance with the manufacturer's instructions in accordance with applicable
local codes.
Use only attachments/accessories specified by the manufacturer.
®
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
Installation Manual
Safety | en
5
2019-03 | 1.2 |
Advertisement
Table of Contents
