Setups; Tv Aspect; Progressive Scan; Easylink (Hdmi Cec) - Philips DVP3570/F7 Instructions Manual

TV Aspect

SETUP
Use this feature to adjust the aspect ratio of the video
source which is different from your TV's ratio to fit your
TV monitor without distorting the picture. Descriptions
of each setting are as follows:
Video Your Option
source TV
16:9
Wide
16:9
4:3 Normal
16:9
4:3 4:3 Crop

Progressive Scan

SETUP
You can set "Progressive Scan" to "Off" in "Video" menu or
press and hold [B (play)] on the front of the unit for
more than 5 seconds during playback.
Changing "Progressive Scan" setting is not available while
HDMI cable is connected.
When "Progressive Scan" is "On", video signals from the
unit's VIDEO OUT and S-VIDEO OUT jacks will be distorted
or not be output at all.
1) With "Video" selected in the "SETUP" menu, press
[OK].
2) Select "Progressive Scan" to "On".
3) Press [OK].
4) Select "Yes" using [K / L] then press [OK].
Before proceeding...
Make sure your TV supports the selected item.
Connect with component video cable.
NOTE: If a blank screen appears, wait for 15 seconds
for auto-recovery.
Activate?
Progressive On
Select: K / L

SETUPS

"Video" "TV Aspect"
Description
To enjoy 16:9
picture on 16:9
monitor:
Select this setting
when you want to
enjoy 16:9 picture
on the 16:9 TV.
To enjoy 16:9
picture on 4:3
monitor:
16:9 picture is
scaled down until
the both sides of
the picture fits the
4:3 TV.
To enjoy 16:9
picture on 4:3
monitor:
Both sides of the
picture are trimmed
to fit the 4:3 TV
without distorting
the aspect ratio of
the picture.
"Video" "Progressive Scan"
Yes
No
Set:OK
5) Select "Yes" using [K / L] then press [OK].
6) Press [OK] to complete "Progressive Scan" setting.
Note
• If there is no picture or you do not press any buttons
for 15 seconds, "Progressive Scan" will switch to "Off"
and it will exit the "Progressive Scan" setting.

EasyLink (HDMI CEC)

SETUP
EasyLink (HDMI CEC) function allows your TV (limited to
PHILIPS brand EasyLink TV) to act in conjunction with this
unit, or vice versa.
When "EasyLink (HDMI CEC)" setting is set to "On",
functions listed below will be available.
One Touch Play
When this unit is turned on, the TV also is turned on and
the appropriate external input channel will be selected
automatically. The appropriate external input channel can
also be selected on your TV automatically when you press
[B (play)], [ (previous)], [
[the Number buttons] or [INFO
power is on.
Standby
When you press and hold [y y (standby-on)] for 2
seconds, it turns off the power of the TV first and then
turns off the power of this unit also.
System Information
Get & Set Menu Language
The unit recognizes the OSD language set for the TV and
automatically sets the same language as the player
menu language (OSD menu language) for this unit.
Refer to the "Player Menu" on page 21 for available
languages.
"EasyLink
"Other"
(HDMI CEC)"
(next)], [SETUP],
] when the unit's
EN 23