Advertisement
This voltage level is user adjustable to maximise the number of bait drops, however, should
only be modified with caution and with safe testing over land.
The parameter to use in the phone APP for adjusting this is : FS_BATT_VOLTAGE
By reducing this value, your drone will have more fly-time, but will have a smaller
reserve tank. Too low can damage the battery and cause drone to behave erratically or
crash. We suggest to NOT set this below 14.2V for 4S or 21.3V for 6S.
If low battery is reached whilst flying, the drone will disable pilot input and immediately
activate RTL. Control will be issued back to pilot once the drone starts descending.
For battery life safety, we suggest that you always fly your drone with a small load of
250grm. This will allow the voltmeter to detect a low battery condition before battery
power has been fully depleted. VERY IMPORTANT.
Note: Always press button "B" to drop the bait, if the drone is returning with the bait
attached.
Geofence
The MAX distance is set at the factory to the legal limit of 500M. The Altitude fence is set to
35M. These parameters can be wirelessly adjusted on the phone and uploaded to the
drone. This is useful when you know there are REEFS at a certain distance, and you do not
want the drone to exceed that limit.
The drone will stop at the max distance. If the drone breaches the GEOFENCE (distance or
alt), then RTL will be activated. Pilot will not have control until drone hovers over the launch
site.
If the altitude limit is BREACHED, the drone will first descend to a safe height and then RTL.
Be careful NOT to override the drone if it is in low battery landing mode. It is not safe to fly
if the battery is LOW.
DONOT upload parameters whilst drone is flying. Always re-start the drone to save new
settings.
To change the GEOFENCE (DISTANCE MAXIMUM) use this parameter in the phone app:
FENCE_RADIUS
(see video on how to use the APP)
The factory setting is 500M to meet legal requirement.
7 |
P a g e
Advertisement
