Advertisement
16. Check and test your trace for good release before flying.
a. Test the bait drop mechanism.
b. Take-off with the payload to see how the load behaves in flight.
c.
After dropping the bait use RTL or manual flight to return to launch site.
d. Immediately drop the bait if the craft wants to return home due to low battery.
e.
If signal is lost to the craft from the remote, the bait will drop, and the craft will return
to launch.
17. Taking manual control
a.
To dis-able any "AUTO" mode, click the button "A" twice. (Click Click)
18. Auto- Landing – press A to initiate a Auto Land.
19. Low battery landing – The craft will initiate a RTL when it detects a low battery. Immediately
release the bait by pressing BUTTON B and allow the craft to land or land manually.
Liabilities
No drone is 100% reliable all the time. Make sure that you can fly in NON-GPS mode if there is a loss of
satellites or any GPS glitch.
20. Battery care
• DO NOT leave on FULL charge when not in use
• Do NOT leave on LOW charge when not in use.
• Please store battery at 3.8V per cell
• Very heavy baits will reduce battery life.
• Check worn out battery terminals
• Treat the battery terminals occasionally with anti-rust fluid. Treat all the wires at the point
that they go into the battery so that the anti-corrosion formula can protect the terminals
inside the battery.
• Treat the copper plugs on the XT90 yellow plug.
• Make sure you do battery lubing after salt water exposure.
21. Study the LIPO voltage card in Manual.
Use this LIPO voltage chart to assist you with your battery condition checking.
1 Cell
2 cell
3 cell
4 Cell
5 cell
6 cell
Advertisement
