Autel AutoLink EBT 210 Manual page 16


The sequence of the DTCs, total number of codes
detected and type of codes (stored or current) will be
observed on the display.
3) When more than one DTC is found, use UP/DOWN button,
as necessary, until all the codes have been shown up.
 If no codes are detected, a "No codes are stored in
the module!" message displays on the screen.

If the code definition is not found in the built in DTC
library, a "DTC definitions not found! Please refer to
vehicle service manual!" message comes up
prompting you to look up the definition in the vehicle
service manual.
4) Press N button to return to previous menu.
B. Erasing Codes
CAUTION: Do not erase the codes before the system has
been checked completely by a technician.
This function is performed with key on engine off (KOEO).
Do not start the engine.
1) Use UP/DOWN button to select Erase Codes from
Diagnostics Menu and press Y button.
C2117
stored
Control unit A7/3n1
(SBC control unit),
Internal fault
...... Read Codes
No Codes are stored
in the module!
Press any key to continue
15
2/3
... ...