Autel AutoLink EBT 210 Manual page 15

 Verify that the ignition is ON;
 Check if the brake tool's OBD II connector is securely
connected to the vehicle's DLC;
 Turn the ignition off and turn it back on 10s later.
 If the "LINK ERROR!" message does not go away,
then
there might be problems for the brake tool to
communicate with the vehicle. Contact your local
distributor or the manufacturer's customer service
department for assistance.
3) To exit the SBC test, press N button from Select Function
menu, and a prompt comes up asking your confirmation.
4) Press Y button to confirm if you do wish to exit; if you do not
wish to return, press N button or use UP/DOWN button to
select NO and then press Y button to continue.
A. Reading Codes
1) Use UP/DOWN button to select Read Codes from Select
Function menu and press Y button to confirm.
2) View DTCs and their definitions on screen. If the code
definition covers more than one screen, use Y button to turn
to next page(s) to view additional information.
............ .Exit
Exit SBC Test!
Are you sure?
YES
..... Select Function
► 1) Read Codes
2) Erase Codes
3) Deactivate Brake
4) Activate Brake
Test........... ...
NO
.. ...
1/5
14