Prerequisites; Hardware And Software Components - Siemens SINAMICS S120 Getting Started

Starter commissioning tool

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Prerequisites

This chapter describes the prerequisites for step-by-step configuration and com-

missioning.

The configuration and commissioning steps are described in detail in Chapters 3

and 5.

2.1

In our example, a drive unit is to be assembled for a motor.

The following components are required for the drive unit:

S Active line module

S Control unit CU320

S Motor module

S Sensor module SMC20

S Synchronous motor (e.g. 1FK6) or induction motor (e.g. 1PH7) with sensor

S DRIVE-CLiQ cables

You will also need line filters, line reactors for the active line module, motor, power,

and encoder cables, as well as a SITOP modular 24 V DC power supply, for exam-

ple.

The following prerequisites must be fulfilled before you start commissioning:

S CompactFlash card with firmware

S The components are wired by means of DRIVE-CLiQ

S The PROFIBUS interface control unit is connected to a PC/PG via a PROFI-

BUS interface

S The STARTER commissioning tool must be installed on your PC/PG

Note

For instructions on wiring the components, connecting the PROFIBUS interface to

a PC/PG, and installing the STARTER commissioning tool, see the Equipment

Manuals /GH1/ and /GH2/ and the Installation and Start-Up Manual /IH1/.

SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition

2-19

Table of Contents