2.16.2 Usbb1 Phy Interface; Figure 14 - Panda Usbotg Interface Block Diagram - pandaboard OMAP4460 ES System Reference Manual

2.16.2 USBB1 Phy Interface

The Pandaboard ES uses the 12-wire OMAP4460 USBB1 ULPI interface connected to an SMSC
USB3320C-EZK phy. This Phy converts the 12-wire ULPI interface to a DP/DM pair that is used as the
upstream USB interface to the LAN9514 USB/Ethernet Hub IC. The Hub IC provides four downstream
Host USB ports, and an Ethernet interface. Two of the USB Host Ports are available via the combo
connector J9, while the other two ports are available via Expansion Connector J6. The Ethernet interface
is available via a tab-up RJ-45 connector at J9. See Figure 15 for a block diagram of the Pandaboard ES
USBB1 interface connectivity.
 Note that the reference clock to the USB3320C is sourced from the FREF_CLK3_OUT output
of OMAP4460, and this OMAP output must be programmed for a clock frequency of 19.2 MHz
for proper operation
Downloaded from Elcodis.com electronic components distributor
OMAP4460 Pandaboard ES
System Reference Manual
Figure 14 – Panda USBOTG Interface Block Diagram
Revision 0.1
September 29, 2011
DOC-21054
Page 40 of 82