Display Interface; Figure 8 - Panda Display Interface Block Diagram; Table 4: Hdmi Gpio Definitions - pandaboard OMAP4460 ES System Reference Manual

GPIO
GPIO_41
GPIO_60
2.13
The Pandaboard ES provides two possible options for the usage of the OMAP4460 parallel display
signals. The first option is to use the onboard TFP410 DVI transmitter, whose output feeds an onboard
DVI-D connector. The second option is to use a Display Board plugged into a pair of 20-pin LCD
expansion connectors (J1 and J4).
paragraphs. Additionally, a third display option has been added to the OMAP4460 Pandaboard ES. This
option is using a DSI Display Board plugged into connector J7 on the back side of the PCB. See Figure 8
for a diagram of the Pandaboard ES Display Interface options.
Downloaded from Elcodis.com electronic components distributor
OMAP4460 Pandaboard ES
System Reference Manual
Dir Signal Name
O HDMI_LS_OE
O HDMI_CT_CP_HPD

Table 4: HDMI GPIO Definitions

Display Interface

Both of these possible options are discussed in the following
Figure 8 – Panda Display Interface Block Diagram
Description
TPD12S015A Level Shifter and internal LDO Enable
1 = Enabled, 0 = Disabled
TPD12S015A DC/DC Converter and Hot-Plug Detect
Enable 1 = Enabled, 0 = Disabled
Revision 0.1
September 29, 2011
DOC-21054
Page 31 of 82