Advertisement
6.2. Remote Control
6-2.1. Key Function
1. LEFT: Hold on to turn TV left
2. RIGHT: Hold on to turn TV right
3. UP: Hold on to tilt TV up
4. DOWN: Hold on to tilt TV down
ON: One push to extend cart to the programmed
operating position automatic all. (Vertical position)
OFF: One push to back cart to the programmed
storage position automatically. (Horizontal position)
6-2.2. Operation instruction
1. Aim the LED indicator on remote control at TV. The remote range is 3-10m.
2. When you press one of the function key on remote control straightly (raise, lower, left, right, up,
down) the mount will move to the direction you expected. Loosening, the mount will stop.
3. Insert one 23A,12V battery in the remote control. If the battery ran out, please open the back
cover of the remote control and put in the new one.
6-2.3. Notice:
If any remote control of our product was lost or damaged, you can buy a new remote control with
the same frequency which produced by our company and do following operation:
1. Memory cleaning: pressing coding key about 10 seconds, the memory will be cleaned after the
indicator closed. (The memory is the coding memory of the previous remote control)
2. Use new remote control: pressing any key of remote control and the coding key 1-2 seconds at
the same time, loosening remote control firstly, then loosen the coding key, finally, you can operate
the product with new remote control. (Coding key, Indicator, Please see diagram 2)
Warning:
The top insert holes of main body is
for power input, TV signal input, VIDEO and AUDIO
signal input. The outside signal can be send to main
body through it, do not connect with the inserts holes
of TV directly. Please operate it strictly according to the
installation instruction, otherwise manufacturer will not
bear compensation and law obligation for any damage
and safety problem.
Warning:
The base insert holes of main body is
only to connect the terminal of power input, TV signal
input, VIDEO and AUDIO signal input of TV. Please
operate it according to the installation instruction,
otherwise manufacturer will not bear compensation and
law obligation for any damage and safety problem.
(See diagram 6):
USER'S GUIDE
Page 6
Advertisement
